Green Concept Products: Solar Electric Hand Tools

Thursday, August 19, 2010

At August 19, 2010 at 2:41 AM , Unknown said...: Here are some of the factors we have to look at when we buy crimping players

They have fully to match the type and size of connector we use. That in turn have to be determined based on the wire sections for the cable we use.

They have to be equipped with interchangeable dies in this way we can interchange them for different section or replace if are warn out or defective. They have been equipped with a calibrator attached to that tool body and allow us a very precisely crimping (see product movie). These are the minimal requirements for professional crimping sets

Additional is what Rennsteig a solar industry professional leader for crimping and striping reference as general guidance:

“Make sure the proper inserts, terminal holder, and wire stop are used for the intended terminal and wire gauge size. Check the tool numbers, terminal name, and wire gauge sizes on tool parts, and check the terminal part numbers and cable gauge sizes from authorized wiring diagrams or other documents. If the cable gauge size is not available, strip a sample of cable to be crimped and verify the gauge size by comparing the outside copper core diameter to the charts. (Do not distort or cut strands in the core.) Measuring the strand diameter and number of strands is a more accurate method. Use the formula for cable area (mm²) = 0.785 x (strand diameter in mm²) x number of strands if the cable is not on the chart.”